These NSF Official Listings are current as of Friday, April 05, 2013 at 12:15 a.m. Eastern Time. Please contact NSF International to confirm the status of any Listing, report errors, or make suggestions.
Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://www.nsf.org/Certified/Plumbing/Listings.asp?Company=C0094705&Standard=0MP&
MP
Mechanical Plumbing Products
Mechanical Plumbing Products
| CuraFlo IP LLC | |
| 4035 East Oasis Street | |
| Mesa, AZ 85215 | |
| United States | |
| 800-714-9259 | |
| Visit this company's website |
Facility : # 1 USA
| Product Type | Material Type | Trade Name | Product Standard |
Coating[1] [2] |
Epoxy |
CuraPoxy LS |
ASTM F2831 |
[1] Certified for Immediate Return to Service.
[2] Number of Coats: 1-2
Maximum Field Use Dry Film Thickness (in mils): 40
Maximum Thinner: None
Recoat Cure Time and Temperature: 24 hours at 72°F
Final Cure Time and Temperature: 1 hour at 100°F followed by 4 hours at 72°F
Special Comments: Heat Part A and Part B to 100°F before mixing. Mix ratio of Part A:B
is 3:1 by volume. A 15-minute flush at 2.5-3.5 gpm at the highest possible service
temperature (73°F for cold water, 140°F for domestic hot water, or 180°F for commercial
hot water) is required before placing the pipe back in service.
|
|||
Number of matching Manufacturers is 1
Number of matching Products is 1
Processing time was 0 seconds