These NSF Official Listings are current as of Sunday, February 03, 2013 at 12:15 a.m. Eastern Time. Please contact NSF International to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://www.nsf.org/Certified/PwsComponents/Listings.asp?Company=0M890&Standard=061&


NSF/ANSI STANDARD 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing.  Click here for a list of Abbreviations used in these Listings.

Access-Able Technologies, Inc. 
1275 Bennett Drive
Suite #115 
Longwood, FL 32750 
United States 
800-572-4894 

Facility : # 1 USA

Joining and Sealing Materials

      Water Water
      Contact Contact
  Trade Designation Size Temp Material

Patching Materials [G]
  Pow-R Stick Steel Hard Epoxy Putty (Grey Color) [1] [2] C. HOT EPOXY
  Pow-R Stick Steel Hard Epoxy Putty (White Color) [1] [2] C. HOT EPOXY
  Pow-R Stick Steel Hard Epoxy Putty (Copper Color) [1] [2] C. HOT EPOXY
  STIC-O-STEEL POW-R Putty [1] [2] C. HOT EPOXY 

[1] Certified for a maximum surface area to volume ratio not to exceed 0.3 sq. in./L in pipe
    or 1% of a 20,000 gallon tank.
[2] To obtain the proper mix, use at least a 3/4" length, but no more than 1/3 of a full
    stick, of product which has been cut with a knife. Product must be mixed for 60-90
    seconds.
[G] Product also Certified to NSF/ANSI 61, Annex G and is in compliance with California's 
    Health & Safety Code Section 116875 (commonly known as AB1953) and Vermont Act 193.
    Weighted average lead content <=0.25%; Solder and flux lead content <=0.2%.

Number of matching Manufacturers is 1
Number of matching Products is 4
Processing time was 0 seconds