These NSF Official Listings are current as of Friday, April 05, 2013 at 12:15 a.m. Eastern Time. Please contact NSF International to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://www.nsf.org/Certified/PwsComponents/Listings.asp?Company=38570&Standard=061&



NSF/ANSI STANDARD 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing.  Click here for a list of Abbreviations used in these Listings.


 
Rectorseal Corporation 
2601 Spenwick Drive
Houston, TX 77055 
United States 
713-263-8001
Visit this company's website

Facility : # 1 USA

Joining and Sealing Materials

      Water Water
      Contact Contact
  Trade Designation Size Temp Material

Thread Compounds
  Tru-Blu™[1] [G] >= 1/2" CLD 23 TC
  RectorSeal® T Plus 2®[1] [G] >= 1/2" C. HOT TC
  Pure White Teflon Pipe Compound[1] [3] [G] >= 1/2" C. HOT TC
  RectorSeal® No. 5®[1] [G] >= 1/2" CLD 23 TC

[1] Products were prepared for evaluation according to manufacturer's instructions.
[3] DuPont Registered Trademark.
[G] Product complies with NSF/ANSI 61 Annex G, NSF/ANSI 372 and conforms with lead content
    requirements for “lead free” plumbing as defined by California, Vermont, Maryland, and
    Louisiana state laws and the U.S. Safe Drinking Water Act due to take effect January
    2014.

    

    

Solvent Cements
  Sam™ CL-3[2] [G] >= 1/2" C. HOT CLE
  Sam™ CL-3L - Low VOC[2] [G] >= 1/2" C. HOT CLE

[2] This product is a cleaner that is intended to be used directly before application of a
    solvent cement.  An additional primer is not required.
[G] Product complies with NSF/ANSI 61 Annex G, NSF/ANSI 372 and conforms with lead content
    requirements for “lead free” plumbing as defined by California, Vermont, Maryland, and
    Louisiana state laws and the U.S. Safe Drinking Water Act due to take effect January
    2014.

    

    

Fluxes
  NOKORODE® Regular Paste Flux[G] >= 1/2" C. HOT FLX
  NOKORODE® Aqua-Flux™[G] >= 1/2" C. HOT FLX

[G] Product complies with NSF/ANSI 61 Annex G, NSF/ANSI 372 and conforms with lead content
    requirements for “lead free” plumbing as defined by California, Vermont, Maryland, and
    Louisiana state laws and the U.S. Safe Drinking Water Act due to take effect January
    2014.

    

    


Facility : # 2 USA

Joining and Sealing Materials

      Water Water
      Contact Contact
  Trade Designation Size Temp Material

Patching Materials [G]
  RectorSeal EP200 Epoxy Putty [1] C. HOT EPOXY
  RectorSeal EP400 Epoxy Putty [1] C. HOT EPOXY

[1] Certified for a maximum surface area to volume ratio not to exceed 0.3 sq. in./L in pipe
    or 1% of a 20,000 gallon tank.
[G] Product complies with NSF/ANSI 61 Annex G, NSF/ANSI 372 and conforms with lead content
    requirements for “lead free” plumbing as defined by California, Vermont, Maryland, and
    Louisiana state laws and the U.S. Safe Drinking Water Act due to take effect January
    2014.

    

    


Facility : # 3 USA

Joining and Sealing Materials

      Water Water
      Contact Contact
  Trade Designation Size Temp Material

Lubricants[G]
  RectorSeal® Pipe Lube >= 1/2" CLD 23 LUB

[G] Product complies with NSF/ANSI 61 Annex G, NSF/ANSI 372 and conforms with lead content
    requirements for “lead free” plumbing as defined by California, Vermont, Maryland, and
    Louisiana state laws and the U.S. Safe Drinking Water Act due to take effect January
    2014.

    

    


Number of matching Manufacturers is 1
Number of matching Products is 11
Processing time was 1 seconds