These NSF Official Listings are current as of Sunday, February 03, 2013 at 12:15 a.m. Eastern Time. Please contact NSF International to confirm the status of any Listing, report errors, or make suggestions.

Alert: NSF is concerned about fraudulent downloading and manipulation of website text. Always confirm this information by clicking on the below link for the most accurate information: http://www.nsf.org/Certified/PwsComponents/Listings.asp?Company=4P870&Standard=061&



NSF/ANSI STANDARD 61
Drinking Water System Components - Health Effects

NOTE: Unless otherwise indicated for Materials, Certification is only for the Water Contact Material shown in the Listing.  Click here for a list of Abbreviations used in these Listings.


 
Wavin Overseas BV 
Rollepaal 19
7701 BR, Dedemsvaart 
The Netherlands 
44 1763 247 438
Visit this company's website

Facility : Sully Sur Loire, France

Protective (Barrier) Materials

      Water Water
    Water Contact Contact Contact
  Trade Designation Size Restriction Temp Material

Pipe Liner - Immediate Return to Service[1] [2] [G]
  Innatube 12 mm - 50 mm CLD 23 PET
  Neofit 12 mm - 50 mm CLD 23 PET

[1] Size refers to the internal diameters of pipe that may be lined with Neofit PET liner.
    The PET liner itself is available in unexpanded sizes of 7 mm - 20 mm.
[2] Certified for use as an expandable pipe repair liner when installed in accordance with
    the following expansion process:
    Liner is inserted into pipe and then 85°C - 87°C water is run through the lined pipes to
    expand the liner. Once the pipe has expanded, compressed air is run through pipes until
    the temperature drops to 50°C. The cycle is completed in approximately 30 minutes.
[G] Product also Certified to NSF/ANSI 61, Annex G and is in compliance with California's 
    Health & Safety Code Section 116875 (commonly known as AB1953) and Vermont Act 193.
    Weighted average lead content <=0.25%; Solder and flux lead content <=0.2%.


Number of matching Manufacturers is 1
Number of matching Products is 2
Processing time was 0 seconds